FMWCC35
Portfolio Case
Installation Instructions
PenCentra 130
The PenCentra 130 portfolio case is designed to provide a compact, elegant solution for using and transporting your pen tablet and keyboard.
The portfolio case consists of two distinct storage areas: a pen tablet easel and a keyboard platform.
To open the portfolio, pull up the Velcro® strip that is securing the back flap, as shown in Figure 1. Unzip the wraparound zipper and flip the portfolio open. Extend the back flap so that it forms a stand for the pen tablet. (see Figure 2).
Back Flap
Shoulder Strap | Wraparound |
Zipper |
Figure 1. Closed Portfolio Case
Screen Flap
Tablet
Platform
Easel
Back
Tablet
Ledge
Battery/
Pen Straps
Cable |
|
Strap | Velcro® |
strips (4 places)
Figure 2. Open Portfolio Case
Detach the Velcro® strips securing the vinyl screen flap and lay it over the back of the easel to reveal the pen tablet platform. At the bottom of the platform is a flexible ledge upon which the pen tablet sits. To the right of the ledge is an elasticized strap for securing a spare battery; a smaller strap for securing your pen is affixed to the top of the battery strap.
Installing the PenCentra 130
Tuck your PenCentra 130 behind the ledge lip and lay the system flat onto the platform. It should be a snug fit. When storing your pen tablet in the portfolio, lay the nylon flap over the screen to protect it from scratches. See Figure 3 for a fully assembled system in the portfolio.
Cable
Strap
PS/2
Port
Figure 3. Assembled PenCentra 130 in Portfolio
Installing the Keyboard
To install the keyboard, first remove the adhesive backing from the four Velcro strips that are positioned at the ends of the two strips on the keyboard platform. Holding the keyboard directly over the adhesive strips, carefully lower it so that is centered on the platform. Press the keyboard down to create a strong adhesive bond.
Unfasten the
PenCentra 130 is a trademark of Fujitsu Personal Systems, Inc. © 1999 Fujitsu Personal Systems, Inc.
6/99 |