PYLE Audio PNGTT1 manual E P

Page 16

THE TURNTABLE DRIVE BELT IS FACTORY FITTED – USE THESE INSTRUCTIONS ONLY IF THE TURNTABLE FAILS TO REVOLVE....

S T E P 1

Use a screwdriver to remove the black iron C-clip and lift the turntable off the phonograph mechanism.

STEP 2

Retrieve the dropped black rubber turntable drive belt and replace it around the column on the bottom of the turntable, then pull it out gently without overstretching and hook the band around the small column point at the edge of the turntable, as shown in the diagram.

STEP 3

To fix the turntable back onto the phonograph mechanism, make sure the column point is positioned over the correct place on the phonograph mechanism, while placing the axis of the turntable in the hole on the phonograph mechanism, as shown in the diagram.

S T E P 4

Gently turn the turntable until a ‘pop’ sound is heard, which indicates the repositioning of the rubber band. Replace the C-clip to secure the turntable.

15

Image 16
Contents MODELPNGTT1 Important Safety Instructions Preparation for USE Power Source Front Panel Phonograph Playing Turntable AUX IN/PHONO Recording Audacity and USB Connection Page Page Recording Open the software Output Volume Input Volume Page Page E P