Oracle Audio Technologies 2000 Transport, CD 2000 manual Make the Suspension Housing Sit Lower

Page 8
Make the Suspension Housing Sit Lower

Note: The reference to clockwise or counter-clockwise is determined by viewing the spring module from above. To proceed with minor changes to the suspension fine tuning, please read the following information.

Make the Suspension Housing Sit Lower

If the suspension housing is sitting to high as on this picture.

With one hand apply a light down pressure to the main chassis while holding the suspension housing.

Rotate the spring counter-clockwise by very small increments until the suspension housing lightly rests against the step on the gauge.

Make the Suspension Housing Sit Lower

If the suspension housing is sitting to low as on this picture.

Gently raise the suspension housing with one hand.

Using needle pliers, insert the tip of the pliers near the end of the spring and hold it firmly.

While holding the spring to prevent it from turning, rotate by very small increments the suspension housing, counter-clockwise. This will move the spring further out of the spring calibration sleeve thus making the suspension housing sit higher.

Note: Do not allow the pliers to contact the aluminium parts since this could damage the clear lacquer finish.

Important! In the unlikely event that your Oracle suspension system may need to be completely re calibrated please refer to the caution on the preceding page.

When all suspension towers are fine tuned, install the suspension covers.

Oracle Audio Technologies

8

CD 2500 MK II player / CD 2000 transport Owner’s manual

Image 8
Contents gx Y Çx TÜà Éy cÄtç Çz `âá Oracle Audio Technologies CD 2500 MK II playerCD 2000 Transport FOREWORD FOR YOUR RECORDSTABLE OF CONTENTS CONTENT Small needle pliers PACK AND UNPACK YOUR CDAccessories Foam Block Remove the “C” shape, hold down spacer block SUSPENSION FINE TUNING Suspension fin TuningMake the Suspension Housing Sit Lower Make the Suspension Housing Sit LowerCD 2500 MK II Player CONNECTION PROCEDURECD 2000 Transport Connection to the Pre-Amplifier,CD input POWER SUPPLY CONNECTION Important WarningTHE MAGNETIC DISC CLAMP MaintenanceOperation To Remove the Magnetic Disc Clamp optionSAFE OPERATING INSTRUCTIONS To Play a Compact Disc To Play a Different Compact DiscREMOTE CONTROL OPERATION WHAT IT DOES & HOW TO DO ITFUNCTION KEY Oracle Audio TechnologiesSTOP Oracle Audio Technologiesexact point it was originally suspended Important Warning ROUTINE CLEANING OF THE LASER LENSRoutine Cleaning GMD Fuse Type only FUSE REPLACEMENTFuse Types Oracle Audio Technologies many years of satisfaction