V3-Razr Repair Manual
8.To replace, insert the smart buttons into the phone. Ensure the buttons contact their respective switches on the display assembly.
9.Align the flip cover to the flip assembly, gently press the flip cover onto the flip assembly until the flip cover latches engage.
10.Insert and tighten the 4 screws to secure the flip cover to the flip assembly. Avoid damage to the flex cable.
11.Insert the 4 rubber screw covers over the flip assembly screws.
12.Replace the transceiver board assembly, rear housing, antenna assembly, SIM, battery, and battery cover as described in the procedures.
Removing and Replacing the Camera Assembly
1.Remove the battery cover, battery, SIM, antenna, rear housing, and transceiver board assembly, flip assembly cover, and CLI lens cover as described in the procedures.
2.Unlock the ZIF connector and remove the camera assembly flex connector.
3.Carefully lift the camera assembly and flex out of the flip assembly (see Figure 13).
Fig 13
4.To replace, carefully press the camera assembly into its slot in the flip assembly.
5.Insert the end of the camera assembly flex cable into its slot in the ZIF connector on the flip display assembly. Avoid damage to the flex cable.
6.Replace the flip assembly cover, transceiver board, rear housing, antenna, SIM, battery, and battery cover as described in the procedures.
Page 22
Document
This document is considered an uncontrolled document when printed