Motorola 68014301013, TK30 manual FCC Notice to Users

Page 31

•Conditions inside a parked car can exceed this range. Do not store your accessory in a parked car.

•Do not store your accessory in direct sunlight.

•Storing your fully charged accessory in high-temperature conditions may permanently reduce the life of the internal battery.

•Battery life may temporarily shorten in low-temperature conditions.

Caution About High Volume Usage

Warning: Exposure to loud noise from any source for extended periods of time may temporarily or permanently affect your hearing. The louder the volume sound level, the less time is required before your hearing could be affected. Hearing damage from loud noise is sometimes undetectable at first and can have a cumulative effect. To protect your hearing:

•Start your volume control at a low setting and use as low a volume as possible.

•Limit the amount of time you use headsets or headphones at high volume.

•Where possible, use your headset in a quiet environment with low background noise.

•Avoid turning up the volume to block out noisy surroundings.

•Turn the volume down if you can’t hear people speaking near you.

If you experience hearing discomfort, including the sensation of pressure or fullness in your ears, ringing in your ears, or muffled speech, you should stop listening to the device through your headset or headphones and have your hearing checked by your doctor.

Driving Precautions

Using a mobile device while driving may cause distraction. End a call if you can’t concentrate on driving. Input information about your destination and route prior to your drive. Do not input data or engage in text messaging while driving. Keep your eyes on the road while driving. Listen to the audible turn-by-turn directions, if available.

Also, using a mobile device or accessory may be prohibited or restricted in certain areas. Always obey the laws and regulations on the use of these products.

Responsible driving practices can be found at www.motorola.com/callsmart (in English only).

FCC Notice to Users

The following statement applies to all products that have received FCC approval. Applicable products bear the FCC logo, and/or an FCC ID in the format FCC-ID:xxxxxx on the product label.

Motorola has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment. See 47 CFR Sec. 15.21.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. See 47 CFR Sec. 15.19(3).

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Safety, Regulatory & Legal

29

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Motorola TK30 Page Congratulations Contents Install the vehicle integration kit InstallationBefore you begin Connect the audio cables Vehicle integration kit consists of these connectorsMount and connect the user interface module Select UIM orientation controls on left or right of display Installation Installation Install the microphone Should be no gap between connector and housing Turn off your vehicle’s ignition Set install preferencesSwitch Selective mute featureButtons and scroll knob BasicsHome screen Status icons IconsMusic playing icons Text promptsDevice name Connected Pairing Mode Enter If pin code requiredPair to Bluetooth devices Pair & connectSet Bluetooth device preferences Receive a call CallsJohn Hutchinson Alberts, TreyWhile on a call Say the phone voice CommandSelect Phonebook, Recent Calls, or Dial Number Joe HughesSwap phones Swapping PhonesMusic From a Bluetooth deviceJohn Smith Greensleeves From a USB storage device From an iPod/iPhoneControl your music VolumeAuxiliary Music From an auxiliary deviceSynchronize contacts from your phone PhonebookDownloading Phonebook Set music preferencesRead new message? MessagesMax Chin Set display preferences PreferencesSet user preferences Set audio prompt preferencesEuropean Union Directives Conformance Statement Safety & General InformationSoftware Copyright Notice FCC Notice to Users Avoid turning up the volume to block out noisy surroundingsCaring for the Environment by Recycling Disposal of your Mobile Device AccessoriesPage Page Page 68014301013

TK30, 68014301013 specifications

The Motorola 68014301013, also known as the TK30, represents a remarkable piece of technology in the realm of computing microprocessors. This chip, launched during an era of rapid technological advancement in the 1980s, was instrumental in the development of powerful and efficient computing systems, redefining performance metrics in its time.

One of the key features of the TK30 is its compatibility with the Motorola 68000 architecture, which was renowned for its thorough instruction set and operational efficiency. The TK30 extends this legacy, providing enhanced processing capabilities and improved instructions for complex computations. This compatibility allowed software developed for earlier Motorola processors to run seamlessly on the TK30, giving it an edge in versatility.

The TK30 boasts a 32-bit data bus and a 24-bit address bus, facilitating access to a significantly larger memory space, which is crucial for running advanced applications and managing more substantial datasets. This expanded memory capability was particularly beneficial for developers looking to create sophisticated software solutions or for companies looking to improve their computing power without overhauling their existing systems.

Another remarkable characteristic of the TK30 is its support for multitasking. As the demands for processor efficiency grew, the TK30 was designed to handle multiple operations simultaneously, allowing for smoother and faster execution of applications. This multitasking capability made it a preferred choice for various operating systems, further broadening its appeal in the computing market.

Power management is also a critical aspect of the TK30’s design. The processor employs advanced power-saving features, which help in reducing overall energy consumption, making it a suitable option for embedded systems where power usage is a crucial concern. This focus on energy efficiency aligns with contemporary demands for sustainability and longevity in electronic products.

In summary, the Motorola 68014301013, or TK30, is not merely a microprocessor; it is a versatile, powerful technology that has stood the test of time. With its robust compatibility with legacy systems, impressive memory capabilities, multitasking support, and energy efficiency, the TK30 continues to be relevant in discussions of historical computing innovations, symbolizing an era where microprocessor technology began to pivot towards the complexities of modern computing. Its influence can still be felt as the foundations it laid helped shape the trajectory of future processor designs and computing technologies.
Top Page Image Contents