Motorola T605 manual Installing the Microphone, Installing the External Speaker

Page 7

English

Installing the Microphone

Note: Always use the supplied mounting hardware.

Note: The microphone must be positioned properly or the car kit WILL NOT perform optimally.

1Mount the microphone in a suitable location using either screw, velcro, or clip.

The preferred spot to mount the microphone is on the overhead console/dome light assembly near the front center of the vehicle, away from the window, pointed toward the driver’s head.

Locate the microphone no more than 16 inches (40 cm) from the driver.

Aim the microphone toward the driver.

Do not allow anything (such as a rear-view mirror or sun visor) to block the path between the microphone and the driver.

Mount the microphone firmly so that vibrations do not affect audio quality.

Refrain from locating the microphone directly in the path of heat/AC vents.

Refrain from mounting the microphone on door pillars or windows that can transmit exterior wind noise to it.

Microphone should not be attached to the car’s visor.

2Route the microphone cable down the side of the windshield, through the dash, and to the ECU.

3Connect the microphone to the ECU.

Installing the External Speaker

Important: Do not perform this procedure if you used the ORANGE and BLUE wires on the power adapter cable to connect the audio to the vehicle’s entertainment system.

Note: Always use the supplied mounting hardware.

1Mount the speaker so that the audio is clearly heard by the driver. However, it must not interfere with the safe operation of the vehicle. It is recommended that the speaker and microphone be separated by at least 3 feet (90cm).

Caution: The location of the external speaker MUST NOT interfere with the vehicle’s air bag deployment.

2Connect the speaker to the ECU.

Because you are using an external speaker, you can ignore the 2-pin audio out connector (purple and gray wires) on the power adapter cable.

6

Image 7
Contents Universal Bluetooth Caring for the Environment by Recycling General and safety informationRecycling Mobile Phones and Accessories European Union Directives Conformance StatementPackage Contents Installing the Handsfree Car KitWelcome Installing the Handsfree Car Kit Guidelines for Installation and ConnectionInstalling the Electronic Control Module ECU Electronic Control Module ECU Power Adapter Cable Installing the Power Adapter CableEnglish Installing the External Speaker Installing the MicrophoneInstalling the User Interface Module UIM Installing the Music Audio Adapter CableLinking Your Car Kit and Bluetooth Enabled Device Using Your Car KitAdditional Pairings Initial PairingAutomatic Connection Function Phone T605 Action Making and Receiving CallsFunction Music Device T605 Action Listening to MusicDisconnecting the Car Kit from Your Bluetooth Device Using the Wired Audio InputButton Press Operations Connected Mode Not in a CallConnected Mode In a Call UIM Button FunctionsMusic Mode UIM Indicator Light StatusLight Status Cannot pair my device with the car kit TroubleshootingCannot voice dial a call English Motorola, Inc CFJN4205A