Modifications | Line Card Installation |
|
|
|
|
Line Card Installation
Inserting a Line Card
This section describes the procedures for installing a line card. It also describes the procedures for installing a front plate over an idle line card slot.
Several types of line cards are available (listed below). They are all installed the same way.
„
„
„SMF,
„
„J2 (6.3 Mbps), DS3 (45 Mbps)
„E3 (34 Mbps)
„
„
„
1.Clean the connector with cleaner before inserting the line card.
2.Each line card is equipped with ejectors. Close the ejectors before inserting the card.
Figure 10-10: Line Card Ejectors - Closed Position
3.Insert the line card all the way into the line card slot slowly and positively by running the card through the guide rails. As shown in Figure
Centillion 1200N ATM Switch User Manual | |
NTP |
|
