Panasonic 1200N manual SVC Tunneling, SET Ilmi 00

SVC Tunneling Basic Configuration and Setup

SVC Tunneling

This section describes how to interconnect two ATM Switches (1 & 2) configured for LAN Emulation with an LE client attached to each, over a PVC connection using a SVC tunneling technique.

470079-11111111111111111111						470079-22222222222222222222
	ATM							ATM
	Switch							Switch
		00.n	000		001	00.u
	(1)			ATM Switch				(2)
				(3)
				(PVC)
				VPI = 1
				Clock:
	PC							PC
	LES/LEC							LES/MAT
							133.205.8.54
133.205.8.39

Figure 8-1: SVC Tunneling

1. Refer to Figure 8-1and make cable connections.

2. Set up both LE clients and Switch 3 configurations except for switch interconnections.

3. On Switch 1 and 2, set interface 00 to a NNI port.

4. On Switch 2, set to User Side.

5. On Switch 1 and 2, execute the following commands:

SET tunnel 00 1

SET signal 00 1

SET ILMI 00 1

6. On Switch 1 execute the following command: route add NSAP 47007922 00 1

7. On Switch 2 execute the following command: route add NSAP 47007911 00 1

8. SAVE

NOTE	All signaling, ILMI and SVCs will use VPI and will pass unobstructed through
	Switch 3.

8-14	Centillion 1200N ATM Switch User Manual
	NTP 297-8103-903