Panasonic 1200N manual Backing up Configuration Data, Ethernet Interface, ATM Interface

Periodic Maintenance Maintenance and Operations

Backing up Configuration Data

It is recommended that configuration data be backed up any time there have been changes made to the switch configuration that are intended to be permanent.

Ethernet Interface

1.Connect the TFTP server and the switch Ethernet port to a common Ethernet network. They may be directly connected to each other if an ethernet cross- connect cable is used.

2.Set the Ethernet IP address of the switch using the SET ether command.

3.If the two are not on the same Ether subnet, and are separated by a router, use the SET iproute command to direct the switch to the router.

4.Backup the configuration data using the BACKUP config command.

5.To download a backed up configuration into the switch using the

INSTALL config command.

ATM Interface

1.Connect the switch and the workstation (TFTP server) with an ATM-PVC interface.

2.Setup the ATM-PVC workstation (TFTP server) to use a PVC.

3.Set the IP routing information within the switch such that the switch can upload the configuration data to a host within a different sub network. Use the

SET iproute command.

4.Backup the configuration data using the BACKUP config command.

5.To download a backed up configuration into the switch, use the

INSTALL config command.

9-10	Centillion 1200N ATM Switch User Manual
	NTP 297-8103-903