Modifications

Adding Line Cards

 

 

 

 

Adding Line Cards

Preparation

Hardware Work

Setting the ATM Switch and MAT

Hardware Check

of the Additional

Line Card

Setting System

Configuration

Data

This section describes the procedures for adding line cards to the line slots of the ATM Switch.

Before adding line cards, have the following equipment ready.

The additional line cards

Communication cables for the additional line cards

MAT (not necessary if one is already connected to the ATM Switch)

RS-232C cross cable for connecting the MAT to the ATM Switch (not necessary if already connected)

Phillips screw driver

Antistatic kit and gloves

1.Remove the front plate installed in the line card slot on the front side of the ATM Switch.

2.Insert the additional line card in the line card slot of the ATM Switch.

3.Connect the communication cable for the additional line card to the line card.

4.Connect the new communication cable to other hardware, such as router or terminal.

5.Connect the RS-232C cross cable to the RS-232C connector on the front of the switch/CPU card in the lower right area of the front of the ATM Switch.

6.Connect the other end of the RS-232C cross cable connected to the ATM Switch to the MAT.

1.Turn on the MAT's power switch.

2.Set the communication parameters. (refer to section 6)

3.Check the ALARM LED or MAT monitor and make sure there is no error with the ATM Switch.

Check the additional line card. For instructions on entering the commands, refer to "Line Interface Test" on page 7-19.

Set the system configuration data of the additional line card. For details on the commands, refer to the ATM Switch Command Manual.

Centillion 1200N ATM Switch User Manual

10-25

NTP 297-8103-903

 

Page 141
Image 141
Panasonic 1200N manual Adding Line Cards