Line Card Installation

Modifications

 

 

 

 

hold the ejectors with both hands to insert the card.

Figure 10-11: Inserting the Line Card

Figure 10-12: When pushing the line card in, do not apply excess pressure on the left and right edges of the front of the plate. The plate may become deformed.

Make sure the line card is fitted into both right and left guide rails before inserting it. If the line card is slid outside of the guide rails, it may cause a short-circuit.

Push the line card slowly all the way into the slot. Otherwise, improper con- tact may result. In addition, a failure may result if you insert the line card too quickly.

4.Tighten the screws on the left and right of the ejectors to fix the line card in place.

5.Install the communication cable.

Be sure to install a port cap or a loopback cable over line ports that are not in use. Unless an idle line port is covered with a port cap, dust may get inside the port and cause a failure.

10-10

Centillion 1200N ATM Switch User Manual

 

NTP 297-8103-903

Page 126
Image 126
Panasonic 1200N manual Inserting the Line Card