Panasonic 1200N manual Basic Configuration and Setup Setting up LAN Emulation

Basic Configuration and Setup Setting up LAN Emulation

Use the following steps to set up shaded area of the diagram. All data in this section, including addresses, are examples:

1.Connect cables as in the diagram above and power on all the equipment.

2.Adjust the clock mode of the switch (#2) to SLAVE. The LES is set to provide a MASTER clock.

3.Check the switch’s local information.

DISPLAY network

4.Set the line interface card parameters, ILMI parameters and ATM signaling parameters. (For both PNNI interface port 00 and UNI interface port 03.)

If connections such as an ILMI signaling or PNNI exist for that port, those must be deleted before line interface parameters can be changed.

DEL signaling 00 0 DEL ilmi 00 0

DEL signaling 03 0

DEL ilmi 03 0

5.Set the line interface parameters for PNNI interface port 00.

SET interface 00

Interface (pri_uni0 pri_nni1 pub_uni2)? 1 Forum/ITU (forum0 itu1)? 0

IDLE Cell (unassigned0 idle1)? 0

Valid VPI (0-8[bit])? 6 (based on interface type) Valid VCI (0-8[bit])? 8 (based on interface type) Line Interface 00 has been registered.

6.Set the line interface parameters for UNI interface port 03.

SET interface 03

Interface (pri_uni0 pri_nni1 pub_uni2)? 0 Forum/ITU (forum0 itu1)? 0

IDLE Cell (unassigned0 idle1)? 0 Valid VPI (0-8[bit])? 0

Valid VCI (0-8[bit])? 10

Line Interface 03 has been registered.

If a line interface port is connected to an ATM-NIC, verify that the Valid VPI and Valid VCI values are 0 and 10 respectively. The ATM-NIC in this example only supports VPI=0 and VCI up to 1023.

If the NIC attached to the line interface port carries Management Information Base (MIB) information, ILMI can automatically obtain these valid VPI and VCI parameters, otherwise they must be set manually.

7.For UNI interface port 03 connected to the ATM-NIC, set ILMI timing parameters. ILMI uses VPI/VCI=0/16.

SET ilmi 03 0 16 5 60 20

Centillion 1200N ATM Switch User Manual	8-11
NTP 297-8103-903