Upgrading Software

 

Modifications

 

 

 

 

 

Upgrading

The following software upgrade mode settings are available for the ATM Switch.

 

FLASH

 

FLASH_UP

 

FLASH_UP_SAVE

 

INITIALIZE

 

INITIALIZE_SAVE

 

NETWORK

 

NETWORK_SAVE

 

Use the boot monitor to set the upgrade mode. The boot monitor is started by

 

pressing ESC from the MAT while the booting message is displayed when the

 

power is turned on or the unit is reset. Once in the boot monitor, the display will

 

show the “BOOT” prompt.

 

 

 

 

 

The system is coming up now.

 

 

If you want to enter boot program, push [ESC] key immediately.

 

 

If the [ESC] key is detected within 3 seconds, boot program

 

 

is loaded.

 

 

BOOT#

 

 

 

 

 

Figure 10-22: Starting the Boot Monitor

10-18

Centillion 1200N ATM Switch User Manual

 

NTP 297-8103-903

Page 134
Image 134
Panasonic 1200N manual Upgrading, Networksave