Nostalgia Electrics KRS-2150 manual Tapping the Beer KEG, HOW to Operate

TAPPING THE BEER KEG

(SINGLE VALVE-TYPE KEG)

ENGLISH

Connect to the	Connect to
Beer Line Tube	CO2 Gas
	Line Tube
Black pull handle

Keg Coupler

fig. 1

	CK	W
		IS
LO			E
C
N
R
U
T

Beer Keg Neck

fig. 2 fig. 3

Lift Upright

Beer Keg

Keg Support

fig. 4 fig. 5

Follow these steps below to tap the beer keg.

1.Make sure the black pull handle of the coupler is in the closed (up) position before installing it on the keg (Fig. 1). Insert the coupler into the locking neck of the beer keg and turn clockwise until it locks into position (Fig. 2). This means that it is secured to the keg.

2.Make sure the beer tower faucet is in the closed (handle pointing straight back) position before connecting the coupler to the keg (Fig. 3). To secure

the tank connection, pull the coupler handle out and push down until it locks into position. Listen for the “click” of the pull handle when it shifts into the final downward position (Fig. 4). This will open the beer and CO2 gas valves. The keg is now tapped.

3.Carefully tilt the keg and rest the edge on the keg base board on the bottom of the interior cabinet. Slide the beer keg slowly, ensuring that it is properly located (Fig. 5) and carefully close the door.

HOW TO OPERATE

Follow the steps below to dispense beer.

1.Make sure that the KEGORATOR™ is plugged in properly to a 120V, 60Hz, 15 Amps grounded AC outlet.

2.Place the drip tray under the beer faucet to avoid messes from excess beer.

3.Open the beer faucet by pulling the tap towards you to dispense the beer. If for any reason the beer does not come out of the tap, please refer to the Tapping the Beer Keg section.

4.Increase the pressure if the beer runs too slowly (see Regulator section).

5.Hold the glass steady at a 45° angle. When it is ²/ 3 full, straighten the glass. Proper foam should be a tight creamy head and the collar on an average glass should be ¾” to 1” high, ideally.

13