CO2 & TAP TOWER INSTALLATION
You must read and understand the steps below for the CO2 assembly before installation. When you purchase the first keg of beer, you must also have your CO2 cylinder filled at your local supplier. CO2 tanks can be refilled at locations such as welding supply shops, party stores, or wherever kegs are purchased.
ENGLISH
STEP 1
Make sure white nylon High Pressure Washer (already installed) is attached to CO2 Double Regulator.
STEP 5
After the Backflow Stopper has been inserted, remove the three parts above.
(cont. on next page)
STEP 2
Use Wrench to attach Double Regulator to CO2 Tank connector.
STEP 3
Remove spring from inside the Keg Coupler. If spring is not present, go on to Step 4.
STEP 4
Make sure Backflow Stopper is insterted in the Keg Coupler (the Backflow Stopper goes in with rounded side down).
10
