HELPFUL TIPS
•It is recommended that you flush the hoses with water prior to first use to remove any dust and debris from shipping.
•Only open the CO2 Tank ¼ turn to begin with and then use the regulator to adjust to desired pour. If it is not enough, continue to open the CO2 Tank by ¼ turn and use regulator until desired setting is reached.
•It is normal to see condensation form on the faucet. It is caused by the difference in temperature between the cold beer and the inside of the faucet when beer is flowing through the line.
•If your CO2 Tank Band breaks during assembly, it is recommended to use a bungee cord to secure CO2 Tank.
CLEANING & MAINTENANCE
Follow the steps below to clean the keg tap and hoses. (see illustration below)
ENGLISH
1.Turn off CO2 completely before attempting to clean.
2.Remove the hose from the coupler and carefully twist the dispenser faucet off the top of the KEGORATOR™.
3.Ensure that the dispenser handle is in the down position before flushing the hose. If this is not set correctly, water cannot flow through. Hold the open end of the hose under running water for
4.In order to clean and remove any excess beer that may leak into the unit space inside the
1Detach beer line
2Flush hose with water
door, remove the black rubber insulation and wipe with a wet towel as needed. Follow the guidelines below to care for your KEGORATOR™ when not in use.
•Please adjust the temperature gauge to MIN in colder environments because this unit does not
•Always rinse the beer line if you do not intend to use your KEGORATOR™ for a period of time. First, turn off the CO2 and dispense beer until it stops. This will release pressure in the keg so that the coupler can safely be detached.
•To avoid permanent damage to the unit, never use sharp objects inside the KEGORATOR™.
14
