Safety Measures

Precautions on Handling the Product

 

 

 

 

Safety Measures

Power Supply

Installation

For safety, be sure to use a three-pin outlet for power supply with a grounding receptacle. Lack of grounding may cause electric shock.

To prevent electric shock, do not touch the equipment with wet hands when it is connected to a power supply.

Do not plug the power cable of this equipment into an outlet with excess load. Putting excess load on one outlet may cause the outlet to overheat and start a fire.

Do not place a heater near the power cable, place a heavy object on the power cable, or forcefully pull the power cable. Doing so may cause damage to the power cable and cause electric shock or fire.

Place the equipment indoors.

Place the equipment where the temperature is 41 to 104°F (5 to 40°C) and humidity is 10 to 80% (without condensation).

Condensation happens when moisture in the air attaches to the surface of metallic panels, etc., and turn into water drops. Condensation may occur inside the equipment when the temperature inside the equipment is low and the room temperature is high. Note that condensation may cause the equipment to fail.

To prevent electric shock or a failure, do not place the equipment where it is susceptible to such liquids as water and oil, steam, or where the humidity is high.

Place the equipment where the floor is flat and has adequate strength.

To prevent a failure or deformation, do not place the equipment where it is exposed to direct sunlight or near fire or such heaters as stoves.

To prevent a failure, do not place the equipment in a dusty area.

Do not block the vents in the bottom, back, or top (rack mount) of the equipment. Blocking the vents will cause the temperature in the equipment to rise and may cause a failure or fire.

1-2

Centillion 1200N ATM Switch User Manual

 

NTP 297-8103-903

Page 14
Image 14
Panasonic 1200N manual Safety Measures, Power Supply Installation