Toshiba B-450-QQ owner manual Installation Procedure, Installing The Supply Holder Unit

Models: B-450-QQ

1 28

Page 11

EO1-33006

6.1 INSTALLING THE SUPPLY HOLDER UNIT

WARNING!

Turn the power OFF before installing the supply holder unit.

Fit the two studs on the bottom of the printer into the holes in the supply holder unit.

Supply Holder Unit

Fig. 6-1

WARNING!

Turn the POWER SWITCH to OFF before connecting the power cord or cables.

Parallel Interface Cable (Centronics)

Serial Interface Cable (RS-232C)

Power Cord

Fig. 6-2

6-1

Image 11

Contents

TEC Thermal Printer Table of ContentsB-450-QQ SERIES Owner’s ManualSafety Summary Safety SummaryMeanings of Each Symbol Safety Summary PrecautionsRequest Regarding Maintenance TABLE OF CONTENTS B - 4 5 2 - T S 1 0 - Q Q 1.2 ACCESSORIES1. INTRODUCTION 1.1 APPLICABLE MODEL2.2 PRINTING SPECIFICATIONS 2. SPECIFICATIONS2.1 GENERAL SPECIFICATIONS This module strips the label from the backing paper with the 2.3 PAPER LABEL/TAG SPECIFICATIONS2.4 RIBBON SPECIFICATINS 2.5 OPTIONPOWER LED Green 3. APPEARANCE3.1 FRONT/REAR VIEW 3.2 OPERATION PANELDIP SW 4. DIP SWITCH FUNCTIONSThe DIP switches are located at the rear of the printer Interface Cables 5. SET UP PROCEDURE5.2 SETTING UP THE PRINTER 5.1 REQUIREMENTS FOR OPERATION6. INSTALLATION PROCEDURE 6. INSTALLATION PROCEDURE6.1 INSTALLING THE SUPPLY HOLDER UNIT 6.2 CONNECTING THE POWER CORD AND CABLES7. LOADING THE RIBBON Guide Wheel 8. LOADING THE PAPER 8. LOADING THE PAPERPage Batch type FEED 9. THRESHOLD SETTINGFEED PAUSE10. CARE/HANDLING OF THE PAPER AND RIBBON 10. CARE/HANDLING OF THE PAPER AND RIBBON11.1 CLEANING 11. GENERAL MAINTENANCE11.2 COVERS 11.3 REMOVING JAMMED PAPER Cleaning the Cutter UnitAllen Key Cutter 3. Clean the cutter with dry cloth11. GENERAL MAINTENANCE 4. Assembling is reverse order of removalSolution 12. TROUBLESHOOTINGError type ProblemProblem Error typeProblem SolutionAPPENDIX APPENDIXASCII Code Chart Font Sample Barcode Sample INDEX Page E PRINTED IN JAPAN EO1-33006