Upgrading Software

Modifications

 

 

 

 

NETWORK Mode

Load the software from the Ether network server connected via the LAN card mounted in the PCMCIA slot #1. The office data is loaded from the ATA cad mounted in PCMCIA slot #0. Software is not saved.

Figure 10-28: NETWORK Mode

Procedure

1.Turn off the power of the ATM Switch.

2.Insert into PCMCIA slot #0 the ATA card containing the office data you wish to continue to use and into PCMCIA slot #1 the LAN card connected to the Ether network.

3.Turn on the power of the ATM Switch and start the boot monitor.

4.Set the IP address of the ATM Switch.

BOOT# SET local ***.***.***.***

5.Set the server's IP address and boot file name.

BOOT# SET server ***.***.***.*** *****.bootfiles

6.Set the IP address of the default router.

BOOT# SET route ***.***.***.***

7.Set the boot mode as follows:

BOOT# SET boot network

8.End the boot monitor.

BOOT# QUIT

10-24

Centillion 1200N ATM Switch User Manual

 

NTP 297-8103-903

Page 140
Image 140
Panasonic 1200N manual Network Mode