Gaggenau AW 230 790 manual Operating modes, Exhaust air mode, Circulating-air mode, Operation

Operating modes

You can use this appliance in the air extraction or the recirculation mode.

Exhaust air mode

The air that is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system.

Note: Ventilation may not exit through an already operational smoke or exhaust chimney, nor a duct used for ventilating furnace installation areas.

▯If the ventilation is intended to pass through a smoke or exhaust that is not in operation, the responsible area heating inspector must give approval.

▯If the ventilation passes through an external wall, use a telescope wall sleeve.

Circulating-air mode

The air that is drawn in is cleaned by the grease filters and an activated carbon filter and conveyed back into the kitchen.

Note: To bind odors in circulating-air mode, you must install an activated carbon filter. The different options for operating the appliance in circulating-air mode can be found in the brochure. Alternatively, ask your dealer. The required accessories are available from specialist retailers, from customer service or from the Online Shop. The accessory numbers can be found at the end of the instructions for use.

Operation

Note: Turn the extractor hood on when you start cooking and switch it off again a few minutes after you have finished cooking. This is the most effective way to eliminate cooking vapor.

Operating the appliance

Control panel

Explanation

#Fan On/off

1 Fan speed 1

2 Fan speed 2

3 Fan speed 3 Ž Intensive setting ž Run-on funcion œ Saturation display c Light on/off

Turn on the fan

Switching on

For extraction there are three ventilator speeds and an Intensive setting available.

1Press the ÿ button to switch on the appliance. The fan starts in setting 2.

2With the buttons 1, 2, 3 or Ž, set the fan speed according to the cooking situation.

Switching off

Use the ÿ button to switch the appliance off.

8