Securing the appliance

1Press the safety caps with the arrow upwards onto the brackets until they engage. ®

2Screw on knurled nut and washer firmly. ¯

)

*

Removing safety caps

If the safety caps have to be removed, use a flat screwdriver.

Connecting the pipes

Note: If an aluminum pipe is used, smooth the connection area beforehand.

Exhaust-air pipe Ø 150 mm (recommended size)

Attach exhaust-air pipe directly to the air-pipe connector and seal.

Exhaust-air pipe Ø 120 mm

1Attach reducing connector directly to the air-pipe connector.

2Attach exhaust air pipe to the reducing connector.

3Seal both joints appropriately.

Attaching flue duct

9WARNING

Risk of injury

From sharp edges during installation. Always wear protective gloves while installing the appliance.

1Separate the flue ducts.

To do this, remove the adhesive tape.

2Remove the protective foil from both flue ducts.

3Push one flue duct into the other.

Notes

To prevent scratches, lay paper over the edges of the lower flue duct to protect the surface.

The slots of the inner flue duct point downwards.

4Place flue ducts on the appliance.

5Push the inner flue duct upwards and attach it to the angle brackets on the left and right. ¨

6Press the flue duct downwards until it engages.

©

7Screw the flue duct to the sides of the angle bracket using two screws. ª

$

%

&

[

Removing the appliance

1Loosen the flue duct.

2Disconnect the appliance from the power supply.

3Loosen the exhaust air lines.

4Loosen screws for fastening the appliance.

5Remove the appliance.

20

Page 20
Image 20
Gaggenau AW 230 790 manual Connecting the pipes, Attaching flue duct, Removing the appliance