Precor P80 CONSOLE Installing Receivers in Junction Boxes, Receiver and cable slot positioning

12 Installing the P80 Console Media Adapter

Installing Receivers in Junction Boxes

Each external receiver in your facility must be housed in a high-capacity junction box. This enclosure is a direct replacement for an existing T-junction; its ventilation slots and elevated receiver platform keep the receiver cool during use, while space has been set aside on its lower level for the receiver’s power supply.

When you place the receiver in the junction box, position it so that its controls face upward and its connectors face downward, as shown in the following figure.

Figure 3: Receiver and cable slot positioning

Note: If you need to pass the HDMI and remote control cables through the back of the junction box, insert them into the slot in the base of the box (shown in the previous figure). To close off unused raceway openings in the box, insert an end cap as shown in the following figure.

Figure 4: End cap installation in junction box