Using your PowerCase
1.Remove the top cover, slide your iPhone into the PowerCase, then replace the top cover.
2.Your PowerCase will automatically turn on after you connect your iPhone. Your iPhone will use the PowerCase’s battery to power its operation and charge its internal battery.
3.Press the control button to check the PowerCase’s remaining capacity. The status display will illuminate to show the remaining power:
Status Display State | Battery Level |
|
|
One LED is blinking | Below 20% |
|
|
One LED is on | 25% - 40% |
|
|
Two LEDs are on | 40% - 60% |
|
|
Three LEDs are on | 60% - 80% |
|
|
All four LEDs are on | |
|
|
Charging your PowerCase
[Insert image showing the PowerCase connected to an AC charger that looks like our ACMINI wall charger, using the included USB
1.Use the USB cable to connect the PowerCase’s USB
2.If your iPhone is docked to the PowerCase, the iPhone will first charge from your USB charger. The iPhone will charge for about 2½ hours, and then the PowerCase will charge. Note: If you would prefer to charge the PowerCase instead of your iPhone, press the control button. Check your iPhone to see that it has stopped charging.
3.While the PowerCase charges, the status display will indicate the charging status of its battery:
Status Display State | Charge Status |
|
|
One LED is blinking | Below 20% |
|
|
One LED is on, next LED is blinking | 20% - 40% |
|
|
Two LEDs are on, next LED is blinking | 40% - 60% |
|
|
Three LEDs are on, last LED is blinking | 60% - 80% |
|
|