Using Headphones not Included | Jensen JTA-450 guide

4.Sound will then come out from the system’s built-in speakers and the external Amplifier’s speakers simultaneously.

5.Set the VOLUME CONTROL (23) to “MIN” and adjust the sound level using the VOLUME CONTROL on the external Amplifier as desired.

6.Turn the System and the external Amplifier off when you have finished listening.

7.Unplug the connection cable.

USING HEADPHONES (NOT INCLUDED)

This System accepts stereo headphones with a 3.5mm plug and an impedance of 8 ohms or greater.

Inserting the plug of your headphones into the Headphone jack (21) will enable you to listen privately. When using headphones, the speakers will be disconnected automatically.

READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES

1.Avoid extended play at very high volume as it may impair your hearing.

2.If you experience ringing in your ears, reduce the volume or shut off your unit.

3.Keep the volume at a reasonable level even if your headset is an open-air type designed to allow you to hear outside sounds. Please note that excessively high volume may still block outside sounds.

NOTE:

We recommend that you reduce the volume control to a lower level before putting on the headphones. After putting on the headphones, gradually increase the volume to a comfortable listening level.