FIELD REPLACEABLE UNIT DOCUMENTATION
TM
Satellite Pro
6100 Series
14.1” DISPLAY MASK REMOVAL | FL INVERTER AND 14.1” LCD REMOVAL | ||
|
|
|
|
|
|
| LCD module assy | |
Latch |
|
|
|
|
| M2x3 |
|
| M2x3 |
Display | silver |
|
| silver |
screws |
|
| screws | |
mask |
|
| ||
|
|
|
| |
| M2x5 |
|
| M2x5 |
LCD | silver |
|
| silver |
screws |
|
| screws | |
| LCD/ |
|
|
|
Mask seals | FL harness | FL inverter board | M2x4 silver screw | FL cable |
| ||||
1.Remove two mask seals at the bottom corners of the display assembly using a pair of
2.Remove two M2.5x6 black flat head screws securing the display mask.
3.There are 23 latches securing the display mask. Carefully insert your fingers between the mask and the LCD panel and pry open the latches starting from the six top latches, to the five latches on each right and left sides, ending with the bottom seven latches.
1.Remove one M2x4 silver screw securing the FL inverter board.
2.Carefully lift up the FL inverter board and disconnect the LCD/FL cable from CN1 and the FL cable from CN2.
3.Remove four mask seals to expose four screws securing the LCD module assembly.
4.Remove four M2X5 silver screws securing the LCD module assembly.
5.Carefully rotate out the top of the LCD module enough to access the display cable
6.Peel off the tape securing the LCD/FL cable and disconnect the cable.
7.Remove four M2x3 silver screws securing the right and left LCD brackets.
TOSHIBA
Tough Enough for Today’s World.