Motorola 100 manual Power Manager Reset

Page 14

Troubleshooting

Power Manager Reset/ - 2

Power Manager Reset

Reset the power manager if the battery and power adapter are proven good, but the computer will not power on. The computer will not reset after a system crash.

To reset the power manager in the PowerBook 100,

Remove the AC adapter and the battery.

Let the unit sit without power hooked up for 3-5 minutes.

Simultaneously hold down the Control, Command, Option, and Power On keys for 5-10 seconds.

Reinstall the battery and, if necessary, reconnect the AC adapter.

Turn on the computer.

Image 14
Contents PowerBook Specifications Processor Memory Disk Storage Interfaces Sound Devices Sound and Video Video DisplayElectrical Power Adapter Troubleshooting General Power Manager Reset Symptom Charts StartupPower Power Power Video Video Video Video Video Video Hard Drive Troubleshooting Symptom Charts/Hard Drive Peripheral Troubleshooting Symptom Charts/Peripheral Peripheral Peripheral Peripheral Internal Modem Internal Modem Internal Modem Internal Modem Miscellaneous PowerBook 100 Startup Problems Flowchart Take Apart Guidelines Backup Batteries Connector Panel Cover Batteries Backup Battery Door Replacement Note Make Backup Battery Door Page Main Battery Page Main Battery Cover Locking Tab Connector Panel Cover Right Cover Peg Display Assembly Page Page Assembly and open Keyboard Take Apart Take Apart Keyboard Palm Rest Cover Page Replacement Note To Trackball Assembly Trackball Cable Connector Hard Drive Take Apart Hard Drive Page Replacement Note If Elevation Foot Take ApartElevation Foot Using needlenose pliers Brightness & Contrast Knobs Contrast and brightness Daughterboard Daughterboard J318J319 Motherboard Take Apart Motherboard Top Cover Clutch Plate Cover Screw Locking Tabs Clutch Cover Replacement Note Position Top Cover Interconnect Cable Speaker Display Bezel Take Apart Display Bezel Page Display Take Apart Display Move the interconnect Inverter Board Display Lamp Cable Connector Sure the blue insulator end Upgrades Fax/Data Modem To install a fax/data modem Modem Connector Cover J1 Connector Standoff J9 Connector Upgrades DOC Remove the fax/data modem Memory Expansion Card Page Page Additional Procedures Fuse Page Additional Procedures Fuse Fuse Fuse Holder Battery Recharger Page Scsi Termination Page Battery Handling Follow these guidelines for Page Battery Verification Set the voltmeter to AC Adapter Verification Page Display Bulb Replacement Caution Replacement Note When Exploded View Power Book