1
3 | 2 | |
| ||
5 | 7 | |
4 | ||
|
31XT Plug-in transmitter adaptor:
Note:The 31XT is designed to turn any wired dynamic
Connecting the 31XT:
Disconnect the microphone cable from the microphone by pushing down on the release button where the microphone and cable connect. Connect the 31XT by lining up the pins on the microphone with the holes on the transmitter, and insert. Push the 31XT into the microphone until it locks into place.
Removing the 31XT:
Push down on the release button and pull out.
(1) | Turn the bottom half of the case counterclockwise until it is completely off. |
(2) | Insert one fresh alkaline “AA” battery into the compartment. Make sure |
6
8
battery polarity is correct. Replace the bottom half of the case and turn |
clockwise until snug. DO NOT OVERTIGHTEN. |
9
11
(3) Frequency Label: |
The frequency label indicates what frequency (in MHz) the transmitter broad- |
casts on. The AZDEN receiver in use must also be on the same frequency. |
10 | 12 |
B |
|
A | C |
(4) | Power Off/On:Switches the transmitter off or on. |
(5) | Audio Off/On: |
Slide the switch to “On” for normal operation. Slide it to “Off” to mute the audio.
NOTE: When turning the transmitter on, slide the Power “On” first, and then slide the Audio to “On”. When turning the transmitter off, first slide the Audio to “Off”.
(6)LED:
RED when Power is “On” and Audio is “Off”. GREEN when Power and Audio are both “On”.
page 2 | page 7 |