First Things First
First Things First
EN Mounting Procedure
1.If your cabinet does not have an overhang:
(a)Position Template in desired location on underside of cabinet, flush with front edge.
(b)Then tape Template in place, and go to Step 2 (Read “Caution”).
MEASURE THICKNESS OF
CABINET OVERHANG
Note:
If your cabinet has glue blocks or other obstructions, cut out corresponding areas on the Template to clear them. Do not cut out or cut through the screw holes indicated on the Template.
Note:
It is recommended that safety glasses be worn while drilling screw holes to prevent the possibility of eye injury.
2. Drill 1/4 |
EN
Tips:
On wooden cabinets you may want to mark and start the drill holes with a nail or an awl.
Be sure to hold the drill very firmly against the cabinet to reduce “walking” of the drill bit from the markings.
Use masking tape above the hole locations on inside of wooden cabinet shelf to help reduce splintering.
If installing the unit under a wood cabinet, you may wish to countersink the drilled hole from the INSIDE of the cabinet if a countersink attachment for your drill is available. This will eliminate the use of washers and allow the screw heads to be flush with the floor of your cabinet. If you cannot countersink the holes, use the supplied washers.
FRONT EDGE | MOUNTING |
OF CABINET | TEMPLATE |
If your cabinet has an overhang:
(a)Measure the thickness of the overhang.
(b)Fold front of Template downward along the printed guideline that is closest to the thickness of your cabinet.
(c)Tape
FOLD TEMPLATE ON
DOTTED LINE
underside of the cabinet bottom shelf using |
the 3 points marked on the Template. |
3.Remove Template and clean drill shavings from inside and underside of cabinet.
4.If your cabinet does not have an overhang, go to Step 5.
If your cabinet has an overhang, select the spacer or combination of spacers that is equal to or longer than the cabinet overhang.
3 
4