First Things First Before Plug-In, Automatic Time Set

First Things First

Before Plug-In

EN	CABINET	WASHER		CABINET
EN	OVERHANG	WASHER		BOTTOM
				SPACERS
				3/ " MINIMUM
				3/ " MINIMUM
	EQUAL TO OR			8
	EQUAL TO OR
	LONGER THAN		3/4" MAXIMUM
	CABINET		3/4" MAXIMUM
	OVERHANG

SELECTED SCREWS WHICH MEET MINIMUM,

BUT DO NOT EXCEED MAXIMUM LENGHT.

5.	Insert screws FROM INSIDE THE CABINET. The
	washers must be used on metal cabinets, and
	on wood cabinets if you did not countersink
	the drilled holes. Position washers, flat side
	down, and place screws into the holes.
	If your cabinet does not have an
	overhang, go to Step 7.
6.	Hold screw heads down while you push the
	selected spacers onto the screws under the
	cabinet. Be sure to push up spacers until they
	are firmly against the cabinet bottom and/or
	fully nested (if more than one is used).
7.	Align radio under the screws. Hold the screw
	holes in the top of the clock radio against the

8.Extend cord towards electrical outlet and secure by using the Cord Hooks to hold cord out of the way. For most attractive appearance, place Cord Hooks at back edge of cabinet (on or next to wall) directly over outlet to be used. To attach Cord Hooks, peel off adhesive back and attach to a clean, dry surface on underside of cabinet or back wall. Plug Cord into 120-volt AC electrical outlet. We recommend that the line cord be fully extended for best FM reception.

Automatic Time Set

Selecting Time Zone

The Time Zone switch is located in the battery compartment on the side of the unit.

Open the compartment door by rotating the

lock in the direction of the arrow .

TIME ZONE - Slide the switch to select time zone.

Refer to Figure 1 for U.S. Time Zone details. Refer to Figure 2 for Canadian Time Zone details.

Daylight Saving Time (DST)

After selecting time zone and plugging in your unit, daylight saving time must be activated for those areas observing such change.

The daylight saving button is located in the battery compartment on the side of the unit. Press and hold the DAYLIGHT SAVING button until the icon lights on the display.

To disable daylight saving time, press and hold again until the icon no longer lights.

Warning:

Please avoid playing with these buttons after entering the Clock set mode.

mounting screws and partially tighten the

screws.

Do not fully tighten until all 3 screws have

been started. (The top front edge of the clock

radio should clear the overhang.)

Select 1 for Eastern Daylight Time Select 2 for Central Daylight Time Select 3 for Mountain Daylight Time Select 4 for Pacific Daylight Time