Kyocera KX18 manual Installing the battery, Charging the battery, To install the battery

1 Getting Started

Installing the battery

Your Kyocera phone comes with a removable lithium ion (LI Ion) battery. Fully charge the battery before using the phone.

To install the battery:

1.Hold the phone face down.

2.Slide the tab at the bottom of the door up and remove the battery door.

3.Place the battery in the

phone casing with the metal contacts facing the right side of the phone.

4. Replace the battery door by sliding the notches into the openings near

the top of the phone.

5. Snap the battery door closed to secure the cover into place.

Charging the battery

You must have at least a partial charge in the battery to make or receive calls.

To charge the battery:

1.Connect the

AC adapter to the jack on the bottom of the phone.

2. Plug the adapter into a wall outlet.

The battery icon in the

upper-right corner of the screen tells you whether the phone is:

–Charging (the icon is animated)

–Partially charged

– Fully charged

Recharging the battery

You can safely recharge the battery at any time, even if it has a partial charge.

Note: To remove the battery, make sure the phone is powered off.

Note: If you are using a 400 mA charger with any

of the following part numbers: CV90-G2968-01; CV90-G2610-02; or CV90-60859-1, please be aware that this power unit is intended to be correctly oriented in a vertical or floor mount position.

User Guide for the Kyocera Slider Jet Phone 1