Kyocera Domino S1310 manual Get Started, Phone Battery, Install the Battery, Charge the Battery

1 Get Started

Phone Battery

Install the Battery

To install the battery:

1.Hold the phone face down.

2.Find the notch directly below the back cover. It is square. Using your thumbnail, pry the cover up from the bottom to remove.

3.Place the battery in the battery casing with the

metal contacts facing toward the top of the phone. The metal contacts of the battery

must make contact

with the metal contacts of the battery casing.

4.Replace the battery cover by sliding the notches into the openings on the top of the battery casing.

5.Snap the cover into place.

Charge the Battery

You must have at least a partial charge in the battery to make or receive calls.

To charge the battery:

1. Connect the AC

adapter to the microUSB jack on the side of the phone.

2. Plug the adapter into a wall outlet.

The battery icon in the

upper-right corner of the screen tells you whether the phone is:

–Charging (the icon is animated)

–Partially charged

–Fully charged

You can safely recharge the battery at any time, even if it has a partial charge.

Note: Before removing the battery, make sure the phone is powered off.

User Guide 9