Ericsson GH198 user manual Multi Charger, Connecting the multi charger

Page 62

Multi Charger

AC/DC Converter

The multi charger can be used to recharge standard, slimline and high-capacity batteries. It is to be used indoors with an AC/DC converter.

It takes less then 1 hour to recharge a slimline battery, less than two hours to recharge a standard battery, and less than 3 hours to recharge a high-capacity battery.

Two batteries can be inserted simultaneously -- one in the horizontal compartment, the other in the vertical compartment. A slimline battery cannot, however, be inserted in the vertical compartment.

A standard or high-capacitybattery need not be removed from the phone; the phone can be inserted in the vertical compartment, with battery attached, as shown in the figure above.

The recharging is controlled by a built-in computer. If two batteries are inserted, the battery in the vertical compartment will be recharged first, then the battery in the horizontal compartment.

When a battery is inserted in the horizontal compartment, the computer examines the state of charge of the battery. It then determines whether the battery needs to be discharged or not, before recharging takes place.

Never use the multi charger if the ambient temperature is below 5 °C or above 40 °C

Connecting the multi charger:

To mains socket

Use only the AC/DC converter provided with the multi charger. Use of any other AC/DC converter may be dangerous.

1.Connect the AC/DC converter to the charger.

2.Plug the AC/DC converter into a mains socket.

5

Page 61 Page 63
Image 62
Page 61 Page 63
Contents Ericsson Ericsson Mobile Communications AB Innovatron PatentsSafety and Precautions 1208/4/P/502763Contents Special Functions Introduction About this manualRecharg Overview Key functions Electronic lock SIM -- Subscriber Identity ModulePIN -- Personal Identification Number Observe the followingTurning the Phone On PIN check enabledMaking the Phone Ready for Use SIM not insertedServ indicator flashes Message ‘‘NO NETW’’ No Net- work is displayedIf a number contains more than 10 digits Entering a Phone NumberMaking a Call See also the chapter Dialling Memory and Scratch Pad Ending the callIf a call is unsuccesful Receiving a Call Call Time MeterScratch Pad Volume ControlMicrophone Mute Key LockAlphanumeric Field Status IndicatorsDisplay Numeric FieldFunction Alphabetic ModeCall UseKeypad Recall Store Clear MODE/MUTEAlphabetic mode letter mode PowerVolume control EndNumeric keys Chapter Basic OperationMute -- Privacy key Illumination Audible SignalsRinging Signal Star and HashError Signal Visual SignalsAlarm Signal Confirmation ClickStoring Numbers Storing a Number and NameMemory Protection Memory FullErasing a Stored Number and Name Scrolling through the Memory Numeric and Alphabetic ModeRecalling a Number Using Numeric Mode Alternative Method for Recalling a NumberRecalling a Number Using Alphabetic Mode Speed CallingAppending Digits to a Recalled Number Replacing the Last Digits of a Recalled NumberRecalling the Last Six Numbers Called Dialling MemoryScratch Pad Storing a NumberRecalling a Number Sending Dtmf Signals Sending a CodePre-programmed Dtmf Signalling To send the codeText in the display Special Function ‘‘RETRY OFF’’Accessing a Special Function Using MethodUsing a Combination of the Two Methods Changing a SettingStoring a New Setting Leaving a Special FunctionCall Forwarding Ringing Signal VolumeKey Clicks, Silent Keypad or Dtmf Signals ###Cancelling ALL call forwarding services ‘‘IF BUSY’’ ‘‘NO REPLY’’ ‘‘UNREACHABL’’Call Barring ‘‘ACTIVATE’’ appears ‘‘CANCEL ALL’’‘‘CHG PASSW’’ ‘‘BARRING ON’’ orAutomatic Re-try Changing your password‘‘CHANGE PASSWORD’’ -- -- -- ‘‘CHG PASSW’’ is displayed Available Networks Back LightCurrent Network ‘‘LIGHT AUTO’’ or ‘‘LIGHT OFF’’ or ‘‘LIGHT ON’’Network Selection Mode Automatic Network SelectionDeleting a network List of ‘‘Preferred’’ NetworksReviewing the list of networks Minute Minder Last Call TimeTotal Call Time DigitSIM Unblocking Key Unblocking ProcedurePIN Enabling/Disabling the PIN CheckArea Code Any KeyLanguage Selection ‘‘ANYKEY OFF’’ or ‘‘ANYKEY ON’’, is displayedEntering and storing the area code Battery DischargeBattery Voltage Turning the Area Code facility on or OFFAuto lock Phone LockFull lock Changing your security codeEnabling the electronic lock Disabling the lock or changing the lock levelStandard battery Slimline battery High-capacity Battery BatteriesCare and Maintenance Low battery alarm during a callInserting and Removing a Standard or Slimline Battery Removal InsertionInserting and Removing a High-Capacity Battery Slide indicator RechargingConnecting the basic charger Basic ChargerRecharging a standard battery Hands-Free Vehicle Kit Portable Hands Free Vehicle Power Adaptor and Rapid Charger Recharging a battery and powering the phone Connecting the multi charger Multi ChargerRecharging a battery using the horizontal compartment Recharging a battery using the vertical compartmentObserve the following Flashing Red Indicator Light -- Alarm Signal Sounds Serv Indicator FlashesReceived Signal Is Weak Phone Does Not Come OnMessages Steady Red Indicator LightChanging Your Password ‘‘SIM SECUR’’ or Password changing was successful‘‘UPDATE ERROR’’ ‘‘SIM UPDATE’’ or Inserting the SIM

GH198 specifications

The Ericsson GH198 is a notable mobile phone that emerged in the late 1990s, encapsulating the early era of cellular technology. This device, popular in its time, encompassed several features and characteristics that appealed to users seeking reliable communication solutions.

One of the main features of the Ericsson GH198 was its compact design, which allowed for easy handling and portability. Weighing in at a mere 300 grams, it was lightweight compared to many of its contemporaries. The device boasted a monochrome LCD display, which, while simpler than today's standards, offered clear and readable text for phone numbers and messages. The display was complemented by a user-friendly interface, allowing for seamless navigation through features.

The GH198 operated on the GSM (Global System for Mobile Communications) standard, a significant technology in mobile telephony that laid the groundwork for modern mobile networks. GSM technology enabled the GH198 to provide enhanced voice quality, reliability, and better coverage than previous analog systems. The phone supported various frequency bands, enhancing its usability across diverse regions.

One of the standout characteristics of the Ericsson GH198 was its extended battery life. The device utilized a NiMH battery, which provided talk time of up to 12 hours and standby time of up to several days. Users appreciated this longevity, as it reduced the frequency of charging interruptions, allowing for prolonged connectivity on the go.

In terms of functionality, the GH198 offered essential features such as SMS (Short Message Service) capabilities, enabling users to send and receive text messages—a feature that was gaining popularity during its release. Additionally, the phone included a phonebook memory capacity for storing hundreds of contacts, making it convenient for users to maintain their personal and professional connections.

The Ericsson GH198 also supported functionalities such as call waiting and caller ID, enhancing the overall user experience. Its simple yet effective design made it ideal for both business professionals and everyday users looking for straightforward communication tools.

In summary, the Ericsson GH198 embodied the pinnacle of mobile technology in its era. With its compact design, reliable GSM connection, impressive battery life, and essential communication features, it played a significant role in the evolution of mobile phones, paving the way for future innovations in the telecommunications industry.
Top Page Image Contents