Sharp IM-DR410E Before Recording, About the TOC, Helpful tip when attaching a label

Page 15

Before Recording

IM-DR410E

"About the TOC

Whilst recording or editing, "TOC" (Table Of Contents) appears. If you stop recording or turn off the power after editing, TOC will be written on the MD ("TOC" will flash followed by "TOC EDIT!"). During the process, the lid is locked and you cannot remove the MiniDisc.

TOC display

Warning:

If the power is removed (Battery/AC adaptor) whilst "TOC" is displayed, the MiniDisc unit lid will remain locked until the battery/main power is restored and the unit is turned on. Your new recordings or edited changes will be lost and your MiniDisc may become unusable.

Caution:

Whilst "TOC" or "TOC EDIT!" is displayed, follow the instructions below.

-Do not jerk or bump the unit.

-Do not unplug the AC adaptor.

-Do not remove the battery.

-Do not subject the unit to shock.

Otherwise, tracks may not be recorded properly.

"To prevent recorded MiniDiscs from

being erased accidentally

Slide the accidental erase prevention tab, located on the side of the MiniDisc, in the direction indicated by the arrow.

The MiniDisc will then be protected against accidental erasure.

Recordable Recording prevented

To add a recording to such a MiniDisc, slide the acciden- tal erase prevention tab back to its original position.

"Helpful tip when attaching a label

When attaching a label to a MiniDisc cartridge, be sure to note the following. If the label is not attached properly, the MiniDisc may jam inside the unit and you may not be able to remove it.

!If the label peels off or partially lifts

away, replace it with a new one.

! Do not put a new label on top of an ex- isting one.

!Attach the label only in the specified location.

3

Preparation	Before Recording-
	-

15

IM-DR410E TINSE0550AWZZ

03/7/21 IM-DR410E_2.fm

Image 15

Contents IM-DR410E Special Notes Special NotesImportant Introduction Pole plug earphone optimizes Mobile 1-bit digital amplifier FeaturesFeatures Portable MD player with Mobile 1-bit Digital amplifierContents Accessories AccessoriesNames of Controls and Indicators Important Introduction -Names of Controls and IndicatorsMain unit TOC Indicator Track Number Indicator Display panelReference Storing the unit PrecautionsPrecautions Avoid using or leaving the unit in the following placesPower Source -Using with the AC Adaptor/Alkaline Battery Close the battery coverDo not use a nickel-cadmium battery Inserting a MiniDisc Insertinga MiniDiscClose the compartment door Connections IM-DR410EConnectionsCheck before connecting To cancel the hold mode IM-DR410EHold FunctionPreparation -Hold Function Before Recording Helpful tip when attaching a labelBefore Recording About the TOCRecording Basic Operation -RecordingBefore recording Press the MENU/ENTER button To interrupt recordingTo stop recording To interrupt playback To turn off the powerPlayback PlaybackBasic Operation -Playback Volume controlBass control To customise low and high levelsTo locate the beginning of a track Useful Features -Advanced PlaybackAdvanced Playback To locate the desired portionRandom Random play or repeat playStart recording Useful Features -Advanced RecordingAdvanced Recording Long-play recordingLP4 About the recording modeIndication Recording mode About AtracTo interrupt recording Lect REC ModePlayback sound-actuated recording 12Begin playback on the stereo systemTo create your own track numbers Recording tracks as a single trackNumbering restriction Useful -Advanced RecordingAbout track numbers About sampling rate converterUseful Features -Changing Default Settings Changing Default SettingsTo check the elapsed time and remain- ing time of the track IM-DR410EChecking DisplaysUseful Features -Checking Displays To display the playing time of an indi- vidual trackChecking the remaining amount of bat Tery level Enter button Titling a MiniDiscTitling a MiniDisc Creating disc and track namesCharacters symbols To erase a characterTo enter a space Stamping titles from another MiniDisc What is a master MiniDisc?What is a MiniDisc for stamping? To add charactersTER button Master MiniDisc operation 1 Insert a master MiniDiscTo erase all of the tracks at once Editing a Recorded MiniDiscEditing a Recorded MiniDisc To erase one track at a timeCombined, and press the button To divide a trackTo combine tracks Start playing the track to be divided into twoPlay the track to be moved, and press To move a trackListening through Another System Resuming auto playAnother What is a Net MD portable recorder? About Net MDNet MD -About Net MD Restrictions on audio data Restrictions on check-in and check-outMB or more System RequirementsNet MD -System Requirements Hard disk spaceClick BeatJam Setup Software InstallationInstallation of BeatJam Net MD -Software InstallationNet MD -Connecting to a PC IM-DR410EConnecting to a PCWindows Connecting to aChecking the USB driver Universal Serial Bus controllersTransferring Data Checking outNet MD -Transferring Data MiniDisc System Limitations MiniDisc System LimitationsError Messages Error MessagesTr. Protect Error Meaning Messages No SignalTroubleshooting TroubleshootingIf trouble occurs MaintenanceCleaning Troubleshooting/MaintenanceSpecifications SpecificationsBattery life Input sensitivityOutput level Sharp Corporation