2050_fr_CS196 final_EN 16/1/06 5:35 PM Page 10
Getting Started
General Controls
EN Using the FM and AM Antennas | Installation |
Main Unit - Front View
SOURCE - Selects among CD player, tuner, USB, | EN |
|
Before you use your audio system, you’ll want to make sure both the FM and AM antennas are positioned properly. Uncoil the FM antenna at the back of the unit, making sure it is fully extended (you may even want to tape it to the wall behind the unit if possible. The higher the better.) You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.
Connecting the Speakers
Speaker terminal tabs marked L are for left while R are for right. Each speaker has a black (negative) and a red (positive) wire. When connecting the speakers, match the red wires to the red jacks and the black wires to the black jacks.
To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:
Front View | 10 cm |
10 cm | 10 cm |
| mp3 |
Side View |
|
|
|
|
|
|
| 10 cm | |
|
|
| ||
| ||||
|
|
|
|
|
|
|
|
|
|
5 cm
R S 2 0 5 0
Sleep
DEMO/DIMMER
ON/
STANDBY
CD
|
| mp3 player |
|
SOURCE | REC USB | REC PORTABLE PLAYER |
|
BAND/INFO | BACK | SELECT | TUNE/PRESET |
PHONES |
|
|
|
D I G I T A L M U S I C S T U D I O
mp3 player and AUX. | ||||
BAND/INFO - In CD mode - Selects display | ||||
options to show track elapse time, track remain | ||||
time or disc remain time. | ||||
In mp3 / WMA mode - Shows ID3 tag. | ||||
In USB / mp3 player mode - Shows memory usage. | ||||
In Tuner mode - selects radio band. | ||||
REC | USB - Starts and stops record to USB | |||
device. |
| |||
REC | PORTABLE PLAYER - Starts and stops | |||
record to mp3 player. | ||||
BACK - | In navigation mode - navigates | |||
backwards. | ||||
In rename mode - edits previous alphabet | ||||
SELECT - In mp3 / WMA / USB stop mode - Enters | ||||
navigation mode. | ||||
In navigation mode - navigates forward. | ||||
In rename mode - confirms the editing alphabet | ||||
|
|
| (PLAY/PAUSE) - Starts and pauses playback | |
|
| |||
for CD, USB and mp3 player.
Speaker Wire Connection
Push Speaker terminal tab | Release tab to lock wire in |
down to insert wire. | the terminal. |
NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.
mp3
ON/STANDBY - Press briefly to turn on and off the unit.
DEMO/DIMMER - Activates and deactivates demonstration.
Tips:
In STANDBY mode, press ON/STANDBY to turn the system on in the previously used mode. Press SOURCE to select the corresponding mode. Look at the display icons to identify the current mode.
TUNE/PRESET - Stops CD, USB and mp3 player In record mode - stops recording.
In Tuner mode - selects tune or preset mode. 
(SKIP FORWARD) - In CD mode - Goes to
the next CD track and setting options; searches forward through CD;
In USB and mp3 player mode - Skips to the next file;
In Tuner mode - Tunes up radio frequency.
(SKIP BACKWARD) - In CD mode - Goes to the previous CD track and setting options; searches backward through CD;
In USB and mp3 player mode - Skips to the previous file;
In Tuner mode - Tunes down radio frequency.
3 |
|
|
| 4 |
|
|
|
|
|