ASSEMBLY
Place all parts of the CARDIO GLIDE PLUS in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. THE
FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The included pedal tool 
, and your own
phillips screwdriver 
and rubber mallet 
.
1. Raise the Handlebar Frame (7) to the position shown. | 1 |
| |
Hold the Handle (20) and hook the Link Arms (4) onto |
| ||
|
| ||
the lower Rollers (33) on the Handlebar Frame. |
| 7 | |
Tap two Round Endcaps (8) onto the stabilizer at the |
|
| |
front of the Frame (6). Tap two Round Endcaps onto |
| 33 | |
the stabilizer at the rear of the Frame (not shown). |
| ||
| 4 | ||
|
| ||
|
| 20 | |
|
| 8 | |
|
| 6 | |
2. Turn the Seat Knob (38) to loosen it. Pull down the | 2 |
| |
Seat Knob and slide the Seat (3) onto the Seat Frame |
| ||
| 5 | ||
(5). Slide the Seat to the desired position and release |
| ||
|
| ||
the Seat Knob. Retighten the Seat Knob. Push on the |
| 3 | |
Seat to make sure that the Seat Knob is engaged in |
|
| |
one of the holes in the underside of the Seat |
|
| |
Frame. |
|
| |
|
| 38 | |
3. Press the two Domed Endcaps (13) onto the upper | 3 |
| |
end of the Handlebar Frame (7). | 2 | ||
| |||
Insert the Handlebar (2) into the Handlebar Frame (7). |
|
| |
The sides of the Handlebar must bend toward the seat |
| 13 | |
(not shown). Tighten the four #8 x 1/2” Screws (16) |
|
| |
into the Handlebar Frame and the Handlebar. |
|
| |
|
| 7 | |
|
| 16 | |
4. The Monitor (1) requires two “AA” batteries (not | 4 | Batteries | |
included); alkaline batteries are recommended. | |||
| |||
Insert two “AA” batteries into the battery clip inside the |
|
| |
back of the Monitor. Make sure that the negative |
|
| |
ends of the batteries are touching the springs in the |
|
| |
battery clip. |
|
| |
|
| 1 | |
4 |
| Clip | |
|
|