Assembly

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable spanner , Phillips screw-

driver , and pliers .

Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached.

M8 Nylon	3/8” Nylon		Curved	M8 Split	M8 Flat
Locknut (10)–3	Locknut (33)–4		Washer (42)–3	Washer (55)–3	Washer (51)–3
M5 x 12mm	Ground	M8 x 15mm Button		3/8” x 68mm Carriage Bolt (30)–4
Screw (49)–4	Screw (27)–1		Screw (34)–3

1.Set the Front Stabiliser (2) in front of the Frame (1), with the Wheels (23) on the side shown. Whilst another person lifts the front of the Frame slightly, attach the Front Stabiliser with two 3/8” x 68mm Carriage Bolts

(30)and two 3/8” Nylon Locknuts (33). Make sure that the Front Stabiliser is turned so the Wheels are not touching the floor.

2.Whilst another person lifts the rear of the Frame (1) slightly, attach the Rear Stabiliser (6) with two 3/8” x 68mm Carriage Bolts (30) and two 3/8” Nylon Locknuts

	1	23
	30	23
	30
	23
	2	1
		33
	2	33
		33
		6
	33
	1
		30