Features of the Console, Scan mode | Weslo WLEVEX12920 guide

Mode Indicators

FEATURES OF THE CONSOLE

The easy-to-use console features six modes that pro- vide instant exercise feedback during your workouts. The modes are described below.

Speed—This mode displays your pedalling speed, in kilometres per hour or miles per hour.

Time—This mode displays the elapsed time. Note: If you stop pedalling for a few seconds, the time mode will pause.

Distance—This mode displays the distance you have pedalled, in kilometres or miles.

Calorie—This mode displays the approximate number of calories you have burned.

Heart Rate—This mode displays your heart rate when you use the pulse sensor.

Scan—This mode displays the speed, time, dis- tance, calorie, and heart rate modes, for a few seconds each, in a repeating cycle. Note: The heart rate mode will be displayed only when the pulse sensor is being used.

HOW TO OPERATE THE CONSOLE

Make sure there are batteries in the console (see BATTERY REPLACEMENT on page 11). If there is a thin sheet of clear plastic on the console, remove it.

Follow the steps below to operate the console.

1.To turn on the power, press the ON/RESET button or begin pedalling. The entire display will briefly appear; the console will then be ready for use.

2.Select one of the modes:

Scan mode—

When the power is turned on, the

scan mode will be

selected automati- cally. A mode indi- cator will appear below the scan symbol to show that the scan

mode is selected, and a second

mode indicator will show which mode is currently displayed. Note: If you have selected a different mode, repeatedly press the MODE button to select the scan mode again.

Speed, time, dis- tance, or calorie mode—To select

one of these modes for continu- ous display, repeatedly press the MODE button. The mode indica-

tors will show

which mode is selected. Make sure there is not a mode indicator below the scan symbol.

Note: The console can display speed and dis- tance in either kilometres or miles. To change the unit of measurement, press the ON/RESET button for about five seconds. The letters km/h or mph will appear in the display to show which unit of measurement is selected. When the batteries are replaced, it may be necessary to reselect the desired unit of measurement.