Assembly

Assembly requires two persons. Set the treadmill in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver , adjustable wrench , wire

cutters and needlenose pliers .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

		Handrail Bolt (91)–2
Washer (39)–2
		Screw (80)–6
Handrail Nut (93)–2	Handrail Washer (92)–2	Short Handrail Bolt (89)–2

1.With the help of a second person, carefully raise the Uprights (11) until the treadmill is in the position shown.

Cut the tie from the right Upright (11).

2.Back out the Extension Leg Screw (53). Insert one of the Extension Legs (34) into the treadmill as shown. (Note: It may be helpful to tip the Uprights [11] in the di- rection shown by the arrow as you insert the Extension Leg.) Make sure that the Base Pad (40) is on the indi- cated side of the Extension Leg. Attach the Extension Leg with an Extension Leg Screw. Be sure to push on the head of the Extension Leg Screw while tighten- ing it.

Attach the other Extension Leg (34) in the same way.

1	Tie
	Tie
	11
2
	11
	53
	34
	40