Troubleshooting

Screws

2–3 in.

Walking Belt

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.

1.SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY

a.Replace the batteries in the console (see assem- bly step 7 on page 10).

b.Make sure that the reed switch is properly adjusted (see assembly step 5 on page 9).

c.Make sure that the handrail wire is plugged fully into the wire on the console (see assembly step 8 on page 10).

d.The console, like most electronics, is susceptible to static electricity build-up caused by certain types of clothing or by the operation of the treadmill. If the display is blank or gives incorrect readings, apply an anti-static spray to the hand- rail. Anti-static spray is available where laundry supplies are sold.

2.SYMPTOM: THE WALKING BELT DOES NOT MOVE SMOOTHLY

a.If the walk-

ing belt

is over- tightened,

performance

may be reduced and

the walking belt may be

permanently damaged. Using the hex key,

turn both

rear roller adjustment screws counterclockwise 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walk- ing belt centered. Walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

3.SYMPTOM: THE WALKING BELT SLIPS OR IS OFF-CENTER

a. If the walk- ing belt slips when walked on, use the

hex key to turn both adjust- ment screws clockwise,

1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walk- ing platform. Be careful to keep the walking belt centered. Walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b. If the walk- ing belt has shifted to the left side,

use the hex key to turn the left adjust- ment screw

clockwise, and the right adjustment screw coun- terclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the tread- mill for a few minutes. Repeat until the walking belt is centered.

c. If the walk- ing belt has shifted to the right side,

use the hex key to turn the left adjust- ment screw

counterclockwise, and the right adjustment screw clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the tread- mill for a few minutes. Repeat until the walking belt is centered.