3.Insert a Plastic Shim (97) into each side of the post on the right side of the Base (11). Next, orient the Right Upright (62) as shown, and insert it into the Base. Make sure that the Wire Harness (21) does not fall into the Right Upright. Be careful to avoid pinching the Wire Harness. Note: If necessary, tap the Right Upright with a rubber mallet until it is fully seated in the Base. If the Right Upright cannot be fully seated, remove the outer Plastic Shim and then insert the Right Upright.
Attach the Right Upright (62) to the Base (11) with three 1” Bolts (8) and three Star Washers (9). Do not tighten the Bolts yet.
Assemble the Left Upright (not shown) in the same way.
4.Hold the Crossbar (34) between the Uprights (62, 76). Attach the Crossbar with two 2 1/2” Bolts (53) and two 5/16” Washers (57). Do not tighten the Bolts yet.
5.Identify the Right Handrail (47), which has a large hole in the left side. Feed the Wire Harness (21) up into the rec- tangular bracket on the Right Handrail and out the large hole in the left side. Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the large hole.
Remove any plastic ties that are in the rectangular bracket on the Right Handrail (47). Insert the bracket into the top of the Right Upright (62). Attach the upper and lower ends of the Right Handrail to the Right Upright with two 1” Bolts (8). Do not tighten the Bolts yet.
Attach the Left Handrail (1) as described above. Note: There is not a wire harness on the left side.
Attach the end of the ground wire to the small hole in the side of the Right Handrail (47) with a Silver Ground Screw (96).
3 | 21 |
|
This hole | 62 |
must be
on this side.
|
|
|
| 9 |
|
|
| 97 | 8 |
|
| 9 |
|
|
|
| 8 |
| 11 |
|
|
|
| |
4 |
|
|
|
|
53 |
| 34 |
|
|
| 57 |
|
|
|
|
|
|
| 57 |
|
|
|
| 53 |
|
| 76 | 62 |
|
|
|
|
| |
5 |
|
|
|
|
| 1 | 8 | Ground | 21 |
|
| Wire |
| |
|
|
|
| |
|
|
| 96 |
|
|
| Large |
| |
|
| Hole |
| 8 |
|
|
|
| |
|
| 47 |
|
|
|
| 76 |
| Bracket |
|
|
| 62 |
|
8 |
|
|
|
|
|
| 8 |
|
|
6