Weslo WLTL39093 HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill for Storage

Page 10

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Unplug the power cord. Caution: You must be able to safely lift 45 pounds (20 kg) in order to raise, lower, or move the treadmill.

1. Hold the treadmill with your hands in the locations shown at the right. Caution: To decrease the possibility of injury, bend your legs and keep your back straight. As you raise the treadmill, make sure to lift with your legs rather than your back. Raise the treadmill about halfway to the vertical position.

2.Move your right hand to the position shown and hold the treadmill firmly. Press out on the storage latch. Raise the treadmill until the storage latch closes over the catch.

Make sure that the storage latch is fully engaged over the catch.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of

direct sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° Fahrenheit.

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the stor- age position as described above. Make sure that the stor- age latch is closed fully over the catch.

1.Hold the handrails and place one foot on the base as shown.

2.Tilt the treadmill back until it rolls freely on the front wheels. Carefully move the treadmill to the desired location. Never move the treadmill without tipping it back. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot on the base, and carefully lower the tread- mill until it is resting in the storage position.

Closed

Storage

Latch

Catch

Base

Front Wheels

10

Image 10 Contents
Model No. WLTL39093 Serial No QUESTIONS?Customer HOT Line Table of Contents Important PrecautionsPage Before YOU Begin Left Side Right SideDriver , two adjustable wrenches , and scissors AssemblyExtension Leg Screw while tightening it Harness is not pinched Tighten all parts used in this step and in stepHOW to Plug in the Power Cord Operation and AdjustmentPerformant Lubetm Walking Belt Insert the key fully into the power switch Battery InstallationSTEP-BY-STEP Console Operation Follow your progress with the monitor modes Reset the console and start the walking beltAdjust the incline of the treadmill as desired Measure your heart rate, if desiredHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use Maintenance and TroubleshootingTop Problem The walking belt slows when walked on Exercise Intensity Conditioning GuidelinesWorkout Guidelines Exercise Frequency Suggested StretchesLimited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT Remove this Exploded Drawing and Part List from the Manual R0402A Key No. Qty DescriptionExploded