Weslo WLTL26080 user manual Tighten all parts used in assembly step

Page 6

3.Insert the bracket on the Left Handrail (61) into the left Upright (59). While a second person holds the Console Base (52), carefully insert the Right Handrail (60) into the right Upright (59). Make sure that the lower ends of the Handrails (61, 60) are on the inside of the Base Legs (64) (refer to the inset drawing).

Loosely thread an Upright Bolt (48) with an Upright Washer (38) into each Upright (59).

Refer to the inset drawing. Insert a Handrail Bolt

(71) with a Base Leg Washer (70) into the right Base Leg (64) and the Right Handrail (60). Loosely thread a Flange Nut (9) onto the Handrail Bolt. Repeat this step with the Left Handrail (not shown).

4.Place the Console Base (52) on the Left and Right Handrails (61, 60). Insert the excess Wire Harness (not shown) into the top of the right Upright (59), as you pull the excess Wire Harness (76) out of the bottom of the Upright (see drawing 6). Attach the Console Base to the Handrails with four Console Screws (47).

Tighten all parts used in assembly step 3.

5.Attach the Frame Guide (86) and the Frame Guide Spacer (14) to the left side of the Frame (87) with two Guide Screws (47) as shown. Note: Be careful not to overtighten the Screws. Make sure that the thick end of the Frame Guide is at the bottom.

6.Remove the backing from the Adhesive Clip (78). Press the Adhesive Clip onto the Upright (59) in the indicated location. Press the Allen Wrench (68) into the Adhesive Clip.

Insert the excess Wire Harness (76) into the right Upright (59).

7.The console requires two "AA" batteries (not included); alkaline batteries are recommended.

Open the Battery Cover (56) as shown. Insert two batteries into the battery compartment, with the neg- ative (Ð) ends of the batteries touching the springs. Close the battery cover, push up on the battery cover tab, and then push the tab forward as shown in the inset drawing. Be sure that the tab locks into place.

8.Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or carpet from damage, place a mat under the treadmill.

6

3

 

 

 

52

 

 

 

 

61

76

 

60

Bracket

 

38

48

 

48

59

59

38

 

 

 

60

 

 

 

9

70

 

 

71

 

 

64

 

 

 

4

 

 

52

 

 

 

61

 

 

 

 

47

60

 

 

47

 

 

 

 

 

 

59

5

 

 

 

86

 

 

 

47

 

 

87

 

 

14

Thick end

 

 

6

 

 

 

 

 

 

59

 

 

 

78

 

 

 

68

 

 

 

76

7

 

 

 

 

 

56

Battery Cover Tab

 

 

 

Batteries

 

 

Image 6
Contents QUESTIONS? Model No. WLTL26080 Serial NoCustomer HOT Line Table of Contents Important PrecautionsPage Back Before YOU BeginFront Right SideAssembly Tighten all parts used in assembly step Operation and Adjustment HOW to Plug in the Power CordPerformant Lubetm Walking Belt Reset the console and start the walking belt Diagram of the ConsoleInsert the key fully into the power switch Step by Step Console OperationHOW to Change the Incline of the Treadmill Follow your progress with the monitor displayMeasure your pulse, if desired HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Maintenance and TROUBLE-SHOOTING Problem The power turns off during useTop 2ÓÐ3Ó Conditioning Guidelines Exercise IntensityWorkout Guidelines Suggested Stretches Part LISTÑModel No. WLTL26080 Qty DescriptionExploded DRAWINGÑModel No. WLTL26080 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT