Weslo WLTL29010 user manual HoldtheConsoleBase87neartherightHandrail4

3.HoldtheConsoleBase(87)neartherightHandrail(4).

Makealoopwiththeindicatedplastictieandinsertthe

twoWires(53)throughtheloop.PullonlyenoughWire toconnecttheWirestothetwoconnectorsin the

ConsoleBase(87).Important: Make sure that the

Wires are fully inserted. WARNING: Do not discon- nect or connect the Wires while the treadmill power cord is plugged in.

Refer drawing 3a. Set the Console Base (87) on the

Handrails (4). Thread four Console Screws (3) into the Handrails and the Console Base. After all four Screws

have been started, tighten the Screws until they are snug; do not overtighten the Screws.

Plastic

Tie

3a

87

Feed the excess Wire Harness (53) into the upper end

of the right Handrail (4). Pull the plastic tie tight and cut off the end.

4.Attach the Storage Latch (16) to the left Upright (38) with two Latch Screws (14). Be careful not to over- tighten the Screws.

Refer to step 2. Tighten the four Handrail Bolts (1).

4.Loosley thread the bottom two Weight Rack Screws (13) into the Upright (38). Loosley thread the other four Screws before going back and tightening all the Screws.

Set a 3-lb. Weight (not shown) on the bottom hanger on the Weight Rack (15), a 2-lb. Weight on the middle hanger, and a l-lb. Weight on the top hanger.

Attach the other Weight Rack and Weights (not shown) to the left Upright in the same way.

Plastic

Tie

16

15

13

13

Hanger

6.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.