Weslo WLTL21191 user manual Assembly, Be careful not to pull on the Wire Harness, Screws

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver		and
adjustable wrench	.

Refer to the drawings below to identify the parts used in assembly.

3/4” Screw (55)–6		Extension Leg
	Handrail Bolt (15)–4		Handrail Washer
		Screw (34)–2
			(16)–4

1.With the help of a second person, carefully raise the Uprights (14) to the position shown. Note that the Console Base (6) and the Right Handrail (57) are con- nected to the right Upright with the Wire Harness (26).

Be careful not to pull on the Wire Harness.

Refer to the inset drawing. Insert one of the Extension Legs (41) into the treadmill as shown. (Note: It may be helpful to tip the Uprights [14] in the direction shown by the arrow as you insert the Extension Leg. Make sure that the Base Pad [36] is on the bottom of the Extension Leg.) Attach the Extension Leg with an Extension Leg Screw (34). Be sure to push on the head of the

Extension Leg Screw while tightening it.

Attach the other Extension Leg (41) in the same way.

2.Attach the Storage Latch (12) to the Upright (14) with two 3/4” Screws (55). Be careful not to overtighten the

Screws.

1		26
		6
		57
		14
		14
		34
		41
		36
2
		14
	12	55

5