Weslo 450T manual

6. Apply grease to the shafts on the Upright (1).	6		Apply
		18 19
Slide a Cylinder Spacer (19) and a Resistance			Grease
Cylinder (9) onto each of the shafts on the
Upright (1). Make sure that the indented			19
sides of the Cylinder Spacers are facing the
Upright. Tap a 5/8Ó Axle Cap (18) onto each	Slots		18
shaft.
Raise the Left Pedal Leg (6) and rest it on the			1
	9
hook at the lower end of the left Resistance
Cylinder (9). The hook must be in one of the	6		9
slots under the Left Pedal Leg as shown in the
inset drawing.
Raise the Right Pedal Leg (7) and rest it on the	7
hook at the lower end of the right Resistance
Cylinder (9). Make sure that the hooks are in
the same position under both Pedals.
7. Attach the Right Handlebar (4) to the Upright	7
(1) with two M6 x 12mm Button Head Bolts
(21).	5
Attach the Left Handlebar (5) to the Upright (1)			21
in the same manner.
			4
	1
8. Refer to the inset drawing. The Console (10)	8
requires two ÒAAÓ batteries (not included).
Alkaline batteries are recommended. Press two	Batteries
batteries into the battery clip under the Console.			10
Make sure that the negative (Ð) ends of the
batteries are touching the springs.
Connect the Reed Switch Wire (12) to the
Console (10).
Attach the Console (10) to the Upright (1) with	10	12
four M4 x 16mm Console Screws (22). Be care-			1
ful to avoid pinching the Reed Switch Wire
(12).
		22
9. Make sure that all parts are properly tight-
ened before you use the stepper.
	6