2.Press a Stabilizer Endcap (13) onto each end of the Short Stabilizer (3).
Attach the Short Stabilizer (3) to the Base (2) with two M10 x 65mm Hex Head Bolts (24), two Washers (25) and two M10 Locknuts (15).
3.Attach a Pedal (11) to each Pedal Leg (6, 7) with four M4 x 10mm Screws (28).
4.Slide a Metal Cap (30) onto the indicated shaft on the Base (2). Make sure that the open side of the
Metal Cap is facing the Base.
Apply grease to the shaft on the Base (2).
Identify the Right Pedal Leg (7) which has a Magnet
(26)attached to it. Apply grease to the Pedal Leg Bushings (16) that are in the Right Pedal Leg.
Slide the Right Pedal Leg (7) onto the shaft on the Base (2). Tap a 3/4Ó Axle Cap (17) onto the shaft.
Repeat this step to attach the Left Pedal Leg (6).
5.Slide the Upright (1) onto the threaded bolts in the Base (2). Make sure that the Upright is angled in the direction shown. Attach the Upright with four M10 Locknuts (15).
5
2 |
|
|
|
|
|
|
| 13 | 3 | 25 | 24 |
|
|
|
|
| |
|
| 15 |
|
| 25 |
|
|
|
|
| |
| 2 |
|
|
|
|
|
|
| 15 |
| 13 |
3 | 11 |
|
|
|
|
|
|
|
|
| |
|
|
| 6 |
| |
| 28 |
|
|
|
|
4 |
|
|
|
|
|
|
|
| Apply Grease | ||
| 6 |
| to Shaft |
| |
|
|
|
|
| |
|
|
|
|
| Apply |
|
|
| 30 | 26 | Grease |
|
|
|
| ||
|
| 2 |
|
|
|
|
|
| 7 | 16 | 17 |
|
|
|
|
| |
5 |
|
|
| 15 |
|
|
|
|
|
| |
|
| 1 |
|
|
|
|
| 15 |
|
|
|
| 2 |
|
|
|
|