4.Loosen the two Console Bolts (9) underneath the Console (1), and rotate the Console to the position shown. Push the Right and Left Handrails (6, 7) inward as you tighten the two Console Bolts.
5.Note: You must be able to safely lift 45 pounds (20 kg) in order to do this step.
Hold the treadmill with your hands in the locations shown. CAUTION: To decrease the possibility of in- jury, bend your legs and keep your back straight. As you raise the treadmill, make sure to lift with your legs rather than your back. Raise the treadmill to the vertical position.
6.Make sure that the Latch Pin (78) is in the Storage Latch (77) as shown.
Attach the Storage Latch (77) to the Frame (55) with the three Screws (5). Do not fully tighten the Screws yet. Position the Storage Latch so that the Latch Pin (78) is aligned with the hole in the Left Handrail (7). Slide the Latch Pin into the hole as shown in the inset drawing. Then, tighten the three Screws.
7.The console requires two "AA" batteries (not included). Alkaline batteries are recommended. To install batteries, first touch the Handrail (6) to discharge any static. Next, open the Battery Cover (8). Press the batteries into the battery compartment, with the negative
4 |
|
|
|
| 1 |
|
|
| 6 |
|
|
|
| 9 | 7 |
|
|
| |
5 |
|
|
|
6 |
|
|
|
| 55 |
|
|
| 77 | 77 | 78 |
|
| ||
|
|
| |
5 |
| Hole |
|
| 78 |
| |
|
| 7 |
|
7 |
| 8 |
|
|
|
| |
6 |
|
|
|
Batteries | Battery |
Cover Tab
8.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.
6