Measure your heart rate if desired | Weslo WETL26806.0 manual

The upper display can

show the elapsed time (or the time remaining in a program), the dis- tance that you have

walked or run, the ap-

proximate number of calories you have burned, and the speed of the walking belt. Press the Display button repeatedly until the upper display shows the information that you are most interested in viewing.

Note: While information is shown in the upper dis- play, the same information will not be shown in the lower left or lower right display.

To reset the displays, press the Stop button, re- move the key, and then reinsert the key.

6 Measure your heart rate if desired.

Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from the	Metal Contacts
metal contacts.	Metal Contacts
In addition,
make sure that
your hands are clean.

To measure your heart rate, stand on the foot rails and place your hands on the metal con- tacts—avoid moving your hands. When your pulse is detected, the heart symbol in the lower right display will begin to flash each time your heart beats, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds.

When you are finished exercising, remove the

7 key from the console.

Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when you fold the treadmill to the storage posi- tion, or you will damage the treadmill. Next, re- move the key from the console and put it in a se- cure place.

When you are finished using the treadmill, switch the on/off switch to the “off” position and unplug the power cord.