Assembly

Assembly requires two persons. Set the treadmill in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver , adjustable wrench , and wire

cutters .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

	Handrail Bolt (91)–2
Washer (39)–2
		Screw (13)–6
Handrail Nut (93)–2 Handrail Washer (92)–2	Extension Leg	Short Handrail Bolt (89)–2
Handrail Nut (93)–2 Handrail Washer (92)–2	Screw (53)–2	Short Handrail Bolt (89)–2

1.With the help of a second person, carefully raise the Uprights (11) until the treadmill is in the position shown.

Cut the tie from the right Upright (11).

Tie

2.	Insert one of the Extension Legs (34) into the treadmill	2
	as shown. (Note: It may be helpful to tip the Uprights	2


	[11] in the direction shown by the arrow as you insert
	the Extension Leg.) Make sure that the Base Pad (40) is
	on the indicated side of the Extension Leg. Attach the
	Extension Leg with an Extension Leg Screw (53). Make
	sure to push on the head of the Extension Leg
	Screw while tightening it.

Attach the other Extension Leg (not shown) in the same way.