Weslo WCTL95335.0 user manual Console Diagram, STEP-BY-STEP Console Operation

Page 11

CONSOLE DIAGRAM

 

 

 

Displays

 

Note: If there is a thin sheet of

Key

Pulse Sensor

 

plastic on the console, remove it.

Clip

 

CAUTION: Before operating the console, read the following precautions.

Do not stand on the walking belt when turn- ing on the power.

Always wear the clip (see the drawing above) while operating the treadmill.

Adjust the speed in small increments to avoid sudden jumps in speed.

To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and place only a sealed water bottle in the accessory trays.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 10).

Next, make sure that the reset/off circuit breaker,

located on the treadmill frame Reset near the power cord, is in the

reset position.

Stand on the foot rails of the treadmill. Find the clip at- tached to the key (see the drawing above), and slide the clip onto the waistband of your clothes. Next, insert the key into the console. A tone will sound and the three displays will light. Test the clip by carefully tak- ing a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.

Follow the steps below to operate the console.

1 Insert the key into the console.

When the key is inserted, a tone will sound and the three displays will light.

Press the Start button or the Speed + button to

2 start the walking belt.

A moment after the button is pressed, the walking belt will begin to move. Hold the handrails and begin walking.

As you exercise, change the speed of the walking belt as desired by pressing the Speed buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: The console can display speed and distance in either miles or kilometers (see SPEED DISPLAY on page 12). For simplicity, all instructions in this section refer to miles.

11

Image 11
Contents Model No. WCTL95335.0 Serial No QUESTIONS?Table of Contents Important Precautions Page Back Before YOU BeginRight Side Assembly Page Screws before tightening them Page PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Insert the key into the console Console DiagramSTEP-BY-STEP Console Operation Whenkey. you are finished exercising, remove Change the incline of the treadmill as desiredFollow your progress with the three displays Time/Distance Measure your heart rate if desiredHOW to USE the Upper Body Arms HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Top TroubleshootingProblem The power turns off during use Problem The upper body arms squeak during use Problem The walking belt slows when walked onExercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Limited Warranty Ordering Replacement PartsRemove this Exploded Drawing and Part List from the Manual If a part is missing, call toll-free Key Qty DescriptionR0805A